Scene Controller problem

[hek]

Mabe you could add some Serial.prinln("DEBUG MESSAGE") to see where it fails?

[vampircik]

monitor usb Serial.prinln. I inserted and nothing happens

[vampircik]

[AWI]

@vampircik Try setting the baud rate to 115200 to get any info on the serial port... (unless you changed the baud rate in the sketch). From what I see in the screen dump you are typing "serial.println" in the serial monitor. I guess what @hek meant was to add Serial.println() messages in the the sketch you are running.. ;-)

[vampircik]

Serial.println() messages why?

[mikee]

I had same problem with mega (clone) - tried to program relay and temp node on mega - all over "check wire", and when i switched to uno did compile.

[vampircik]

I installed on Megu examples from libraries all work on the screen shows all. but this sketch nehochet.I wanted to know.

[hek]

The error message you see means that mysensors-library is unable to initialise the radio. Did you enabled soft-spi according to the instructions on the build page?

[vampircik]

I need to do with these files?MySensors / утилиты / RF24_config.h. I know a little something but there is a great desire to understand.

[vampircik]

how to turn it on SOFTSPI in RF24_config.h.?

[hek]

To enable soft-spi you just have to edit RF24_config.h which can be found in your XXX/libraries/MySensors/utility folder. Just remove the commented slashes (//) before "#define SOFTSPI".

NOTE: This change must be reverted back when you have compiled and uploaded code to your scene controller. The normal sensors don't need SOFTSPI enabled.

[vampircik]

Thanks it worked. you are super