[SOLVED] Wifi gateway / motion sensor / value 1107296256 instead of tripped ?

[hek]

Please try the dev-branch gateway version and report back if the problem persist.

[kr0815]

After long trying i managed to install the developer version.
Now the gateway doesn´t receive any messages

I see trough putty the comunication with FHEM, but no messages from the sensor laying next to the gateway

The sensors definetly send, i see it on other wired gateway
Are there any changes in the developer version regarding Channel / ID ?

[hek]

@kr0815 said:

Are there any changes in the developer version regarding Channel / ID ?

No it shouldn't be any changes in that regard.

[kr0815]

That´s really strange, because 2 hours earlier, the gateway worked with the old version, only the problem of receiving numbers instead of v_tripped

I´m using an NRF24L01 with external Antenna, i saw somewhere in the Code there are settings for TX-Power or similar ? Maybe that´s different in dev version ?
Or any other ideas ?

[hek]

Yes, you could try setting tx power to low. Add this before including MySensor.h in gateway.

#define MY_RF24_PA_LEVEL RF24_PA_MIN

Anything useful in the debug log?

[kr0815]

You mean the output when connected with putty ?
There is nothing strange in it, i see the commands from my FHEM controller, but no errors

With the old version i saw also the messages from my sensor nodes

Is it possible to change debug level ?

[hek]

Debug is enabled by default.

https://github.com/mysensors/Arduino/blob/development/libraries/MySensors/examples/GatewayESP8266/GatewayESP8266.ino#L72

You could perhaps have the gateway connected to your computer/Arduino IDE and open the serial monitor to see that sensor readings is picked up correctly.

[kr0815]

Thats what i already did, that´s what i get after a diconnect / connect and then a inclusion-mode on / off in my controller software.

0;255;3;0;14;Gateway startup complete.
0;255;3;0;2;2.0.0-beta
0;255;3;0;14;Gateway startup complete.
0;255;3;0;2;2.0.0-beta
0;255;3;0;5;1
0;255;3;0;5;0

But no messages from the sensors.
Should there be additional messages when in debug mode ?

So as there are no changes in Channel / ID, i see only the possibilities that i either damaged the NRF or that something is different with the Developer version

I´ll try to flash the old software again this evening

[kr0815]

Got it working now, replaced the ampflified NRF with a regular one
Maybe i broke it, but can´t imagine how

In one of the many examples i found the following comment for myConfig.h:

#define RF24_PA_LEVEL_GW   RF24_PA_LOW  //Gateway PA Level, defaults to Sensor net PA Level.  Tune here if using an amplified nRF2401

Is there anything special about the amplified version ? Do they have like a register i have to switch on/ off ? or is it just an additional transistor and the antenna connection ?

[hek]

It requires much more power. Do not feed it from the arduino directly. Especially if you turn up the transmit power level.

[netram]

@kr0815 said:

Got it working now, replaced the ampflified NRF with a regular one

Now that you have the dev-branch WIFIgateway version up and running, did this solve the initial issue with the strange tripped-values?

[kr0815]

Yes, the problem is solved now, no more strange values

[netram]

:thumbsup: