Driving electrical heater
-
Hello,
Would it be possible to drive electrical heater with "mysensors" and Domoticz ?
I'd need to have two outputs to use something like : This
( sorry it's in french)
Thank you@phil77560 It's hard for me to read, because google didn't do a great job on the translation. But I guess it would be possible. It might help if you post the schematics off that schematics on this forum.
-
Hello,
Would it be possible to drive electrical heater with "mysensors" and Domoticz ?
I'd need to have two outputs to use something like : This
( sorry it's in french)
Thank you@phil77560 That would be very well possible. You can drive the led's in the optocouplers from the arduino digital outputs and use a remote "switch" to drive the outputs.
-
Maybe this sketch can be used, since this will read incoming commands, and activate a relay, but for your need as AWI writes, you use the Arduino output direct to your above circuit (Then you don't have to listen to relay click)
https://github.com/mysensors/MySensors/blob/master/examples/RelayActuator/RelayActuator.ino
-
Hello,
Would it be possible to drive electrical heater with "mysensors" and Domoticz ?
I'd need to have two outputs to use something like : This
( sorry it's in french)
Thank you@phil77560 yes, it is possible - I have a SSR switching on a 3kWatt tent with a help of a simple 433Mhz switch controlled by Domoticz. No MySensors in this setup.
