💬 LoRa Ra-01 ATmega328P Node

[NeverDie]

I just now posted the files for Version 3, which allows for an 0805 cap across the Ra-01's 3v3 and GND pads. I just now sent Version 3 to the PCB fabricator.

[NeverDie]

Project completed. It works.

It runs the RadioHead RH95 library and examples without any need for modification. :)

[miljume]

Nice work! Any chance you can post some code samples to interact with MySensors gateway?

[NeverDie]

@miljume

Not anytime soon. Probably better if someone else did.

[pansen]

Out of curiousity: Why did you use a through-hole AVR and not a SMD one?

[NeverDie]

@pansen

Easier/faster to solder.

[pansen]

@NeverDie

I understand but tend to disagree ;)

[nitroburn]

any ideal value for the radio decoupling cap? It is the only thing I don't see listed.

[NeverDie]

@nitroburn said in 💬 LoRa Ra-01 ATmega328P Node:

any ideal value for the radio decoupling cap? It is the only thing I don't see listed.

I'm not sure that it's even needed. I added pads for it in case it might later prove necessary or beneficial, but for now it's optional (unless/until proven otherwise).

[giridhararm]

Is it working ? How to upload sketch using FTDI right

[giridhararm]

Is it working can I use FTDI to post rfm libraries

[NeverDie]

@giridhararm yes

[NeverDie]

Starting with MySensors Release 2.1.1, it appears this module is now supported by MySensors:
"New transport layer: RFM95 (LoRa mode)"