arduino serial monitor gateway problem
-
Hello, I have a problem, I tried to connect raspberry pi with arduino in the domoticz application, I put the project on the arduino which would send information about the motion sensor, when I try to connect the arduino with domoticz after the USB gateway mysensor error pops up "
Error: Serial Port closed ", does anyone know a solution to the problem? Please help
-
@kajoo - if you are having issues on your raspberry it most likley that domoticz is not running as root or atleast have the access to the USB. Same issue occurs when you try to open a serial port with Arduino IDE in linux not run with the right access.
-
@sundberg84
ie the solution is to open the serial port on the Raspberry Pi side yes?
-
@kajoo - i think the resolution is to set the right permissions to the user running Domoticz.
-
@sundberg84
2020-02-27 00:33:15.512 Status: MySensors: Worker started...
2020-02-27 00:33:16.513 Status: MySensors: Using serial port: /dev/ttyUSB0Does this mean that I was able to connect? However, I still have no reaction in the "devices" tab, and the status in the hardware "setup"