ESP8266 WiFi gateway issue

[Hoffan]

I can answer that question by my self.. Its still not working

[hek]

@Hoffan, I verified the inclusion button functionality in the dev branch during the weekend (at least on AtMega but it should work fine on ESP as well).

Just make sure to enable the feature and set a valid ESP-pin. All is documented in sketch.

[Hoffan]

@hek

Okey So i must enable it in the sketch even if i only use the start button in the GUI in Vera

[hek]

@Hoffan
Not the "button" feature (unless you use it), but the "inclusion mode" feature must be enabled.

[Hoffan]

I don't know if i understan you right here, @Hek

if i like to use the start button in vera should it look like this

// Enable inclusion mode
define MY_INCLUSION_MODE_FEATURE
// Enable Inclusion mode button on gateway
#define MY_INCLUSION_BUTTON_FEATURE
// Set inclusion mode duration (in seconds)
define MY_INCLUSION_MODE_DURATION 60
// Digital pin used for inclusion mode button
#define MY_INCLUSION_MODE_BUTTON_PIN 3

[hek]

You only need these two:

#define MY_INCLUSION_MODE_FEATURE
#define MY_INCLUSION_MODE_DURATION 60

[Hoffan]

Yes That i understand, But Nothing is still happening in the GUI men i press start

[hek]

Anything in the gateway log?

[Hoffan]

[hek]

Hmm. ok so message reaches gateway. Good start. It should reply back to Vera. with a
0;0;3;0;5;1

Unfortunately there is no debug log for this in the code. So I can't see if the message is sent to your controller. So either you'll have to look in the Vera log or add a

Serial.println(_ethernetMessage);

Here: https://github.com/mysensors/Arduino/blob/development/libraries/MySensors/core/MyGatewayTransportEthernet.cpp#L170

To see that the message is actually sent back to vera.

[Hoffan]

You mean that i should change that line #170 år just put in the serial string

[hek]

Add the string debug print.