ESP8266 WiFi gateway issue

[Hoffan]

@hek

Okey So i must enable it in the sketch even if i only use the start button in the GUI in Vera

[hek]

@Hoffan
Not the "button" feature (unless you use it), but the "inclusion mode" feature must be enabled.

[Hoffan]

I don't know if i understan you right here, @Hek

if i like to use the start button in vera should it look like this

// Enable inclusion mode
define MY_INCLUSION_MODE_FEATURE
// Enable Inclusion mode button on gateway
#define MY_INCLUSION_BUTTON_FEATURE
// Set inclusion mode duration (in seconds)
define MY_INCLUSION_MODE_DURATION 60
// Digital pin used for inclusion mode button
#define MY_INCLUSION_MODE_BUTTON_PIN 3

[hek]

You only need these two:

#define MY_INCLUSION_MODE_FEATURE
#define MY_INCLUSION_MODE_DURATION 60

[Hoffan]

Yes That i understand, But Nothing is still happening in the GUI men i press start

[hek]

Anything in the gateway log?

[Hoffan]

[hek]

Hmm. ok so message reaches gateway. Good start. It should reply back to Vera. with a
0;0;3;0;5;1

Unfortunately there is no debug log for this in the code. So I can't see if the message is sent to your controller. So either you'll have to look in the Vera log or add a

Serial.println(_ethernetMessage);

Here: https://github.com/mysensors/Arduino/blob/development/libraries/MySensors/core/MyGatewayTransportEthernet.cpp#L170

To see that the message is actually sent back to vera.

[Hoffan]

You mean that i should change that line #170 år just put in the serial string

[hek]

Add the string debug print.