Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Inverse gateway leds behavior

4 Posts 3 Posters 1.5k Views 2 Watching

J Offline
J Offline
John
Plugin Developer
wrote on last edited by

#1

Is it possible to switch the LED blink modes So that they are off and blink on message/error or should i inverse this with hardware?
My Domotica project: http://www.pidome.org
H D 2 Replies Last reply

0
J John

Is it possible to switch the LED blink modes So that they are off and blink on message/error or should i inverse this with hardware?
H Offline
H Offline
hek
Admin
wrote on last edited by

#2

This post is deleted!
1 Reply Last reply

0
J John

Is it possible to switch the LED blink modes So that they are off and blink on message/error or should i inverse this with hardware?
D Offline
D Offline
Damme
Code Contributor
wrote on last edited by

#3

@John My guess whould be to pull the led to VCC instead of GND..
J 1 Reply Last reply

0
D Damme

@John My guess whould be to pull the led to VCC instead of GND..
J Offline
J Offline
John
Plugin Developer
wrote on last edited by John

#4

@hek
[original_post_deleted]

@Damme
Yeah, i think i will go for an HW solution... Maybe with a switch to choose between modes...
My Domotica project: http://www.pidome.org
1 Reply Last reply

0

Log in to reply

17

Online

11.7k

Users

11.2k

Topics

113.0k

Posts

Copyright 2019 TBD | Forum Guidelines | Privacy Policy | Terms of Service