[SOLVED] Network adres (MY_RF24_BASE_RADIO_ID) not loaded to NRF
-
When using Arduino IDE and
#define MY_RF24_BASE_RADIO_ID ((uint64_t)0xA8A8E1FC00LL)adres transfered to NRF is 0x0000000000
this gives high to full rate of ack - lost (st=fail)simple solution is to change definition
#define MY_RF24_BASE_RADIO_ID 0x00,0xFC,0xE1,0xA8,0xA8
-
@olo_25 In the transition of MySensors 1.5 to 2.0.0 the radio ID name changed from BASE_RADIO_ID to MY_RF24_BASE_RADIO_ID.
in 1.5 it was defined as an uint64_t, in 2.0.0 it is an array of bytes.
Perhaps you forgot to convert this when transitioning to 2.0.0?
-
In Arduino IDE library not exist BASE_RADIO_ID, but now I see, definition is equal to my
-
@olo_25 So, issue solved?
-
Solved.
Was solved at start
This is only info for other, I not found info about change of definition when migrating