Anyone using FlashForge Finder?



  • Hi,

    Just wondering if anyone is using (or has used) this printer?



  • Yes, and I am very pleased with it.



  • @mickecarlsson Thanks for the reply.

    I got one back in the summer but not had a lot of time to play with it (5 hours use so far)..... But I have a problem with getting prints to 'stick' to the bed. They always seem to 'lift' at the corners.

    How do you use yours and have you seen the same thing?

    Thanks.



  • Print with a rim. There is a tickbox for it.



  • @mickecarlsson Thanks - I'll take a look at that.

    I did the 'Martian' keyring without problem, but all further prints have lifted. I have tried a few from thingiverse (like shelf hangers and 3D moon) and all have lifted.

    I have used glue stick on the bed, but still have the problem. I also will try and re-calibrate the head and bed leveling when I get time.

    How do you calibrate your printer and is there any good user forums out there you have found to be worthwhile?

    Thanks for the response πŸ™‚



  • I bought Buildtak that I replaced the bed with. I don’t use glue. I did print out a couple of calibration figures that I downloaded from Thingiverse. After a couple of re-calibrations and printing with the calibration figures I have not touched the calibration again.
    However, when I printed the MySensors box from Thingiverse the corners still lifted.
    That was when I found the suggestion to print with a rim.
    Now my prints never lift.
    I also clean the bed after each print with IPA.



  • @mickecarlsson Thanks for the info -

    Do you have a foolproof way to caibrate? Do you level the bed and then calibrate the extruder or the other way around? Any hints or tricks you can share?

    I have some renewed confidence to have another try with this now. Maybe if it is raining this weekend..... πŸ˜‰



  • Just do a regular calibration. Just hand tight the knobs, no force needed. Then start the calibration. Slowly rotate the knob until it the printer beeps. When the calibration is done. Print one of these that fits the bed thingiverse calibration
    Carefully check the result. You should have a consistent print. If not, twist the knob closest to where you need to move re-calibrate. Thin line, the bed need to be closer to the nozzle, thick line that curls, move the bed away.
    Note, when turning the knobs, just move it 1/4th turn each time. And make a note wich knob, the direction (clock wise or counter clock wise).

    To get more info, search on youtube for flash forge finder calibration, there are a lot of videos there.


 

463
Online

7.9k
Users

8.7k
Topics

93.6k
Posts