Hello
hi I have a problem with HA, I can turn on the relay from HA but I can not turn it off, can someone help me?

@boots33 ok thanks does it work, wanting to add another relay?

@boots33 ok, thanks, so if I use switches I should not have problems? I follow this thread

 https://forum.mysensors.org/topic/4847/multi-button-relay-sketch

@dbemowsk I mean if GATEWAY does not work for some problem the node does not work does not turn on light

I have a problem when the radio nrf24l01 loses contact with the gateway does not work the node, how can I do? thank you

Hello, I would like to use this code with 2 relay 2 buttons, help me to change the code thank you very much
https://forum.mysensors.org/topic/6948/synchronising-light-switch

@dbemowsk So you just have to remove the button and put the switch on? or put the switch in parallel with the button?Thank you

@dbemowsk ok thanks clear code explanation, but I did not understand well what to do to hardware part.

@Boots33 ok, tomorrow I try and let me know. Thanks so much

@Boots33 ok, but then the status is updated Domoticz?
thank you

@Boots33 I would like to use with switch, I find nothing on.

@dbemowsk hello I mean switches from classics from home. Thanks

Hi,
I need help for the 'relay Switch' code.
you can help with this code, I would like to use relay as a switch not as a button .
(I'm Italian, I'm sorry for the bad English).
thanks to you.

@Boots33 Thanks a lot works😊😊😊😊😊😁😁👍👍👍

Hi,
I need help for the 'relay button' code. I noticed the code runs well, but if the node losts the communication with the gateway, it can't activate the relay. Can You help me to modify this code to runs the same way also with the node and the gateway stop working to comunicate each other? So, in the case they stop communicating, I Can activate the relay from the node also if It isn't the communication
(I'm Italian, Sorry for the bad english)
Bye.
Relay Example with button: https://www.mysensors.org/build/relay

Hello I would like to know if you can connect an lcd to the gateway, print in the lcd the value of a sensor connected to a node so that both the value on the domoticz lcd controller and the lcd. Do you give me an example? thank you all