I could not decide yet on a platform. OpenHAB should be my next test.

@pgo said:

When interested can post the openHAB items/sitemap(s) settings

Hi, I'm interested. :-)
Or is this the latest version ?

Nice and thanks for the detailed description.

Eb.. no. 360917673897 vendor "liuddndd2009"

How can I update from early Version of MySensor support to the actual PiDome version with new functions? Download and overwrite? The settings are lost?

I still see no difference when CE is disconnected.Only it as work at all.

The left one works with MySensor-Coding, but only with disconnected CE line.

I got the left one from other eb..-"store".

Hi,

I have bought the new modules (right on pic), which operate without modification. I simply swapped and all is fine.
What do I do with the other. How can I test inverted.

Awesome! Thanks for great work!

hm ... if CE inverted, ping sample should not work?! CE must switch between hight and low for TX and RX right? But Ping sample send and receive works.

@Yveaux

Looking at the pictures I have a hard time figuring out the connections for pins 8..12, while these are just the interesting part...

Pin 8?

@Yveaux yes I checked wiring with (http://www.mysensors.org/build/connect_radio)
more detail picture, hope so. (bad light)

@Damme
Chip is covered.

Pictures reflect the curren?t wiring! Same Problem with closer wiring

@aquapro sagte:> Hi,

I have tested 1000 times, wasted complete weekend. Rechecked with built up the wiring from scratch. Same Problem.
Suppose I have swap the cables, which I doubt, why it works when I disconnect it completely?

I have all the cables replaced, also new from different suppliers. I used the next pins on the Arduino. For the pictures I have to build something stretched to better overview.

If I disconnect orange wire (red marker on first sensor picture), sensor works fine.

Sensor figures:

Gateway figures:

Yes, checked with 5 Arduinos (all different vendor's) and 8 radios. Same Problem. I am totally confused.

Hi,

I have tested 1000 times, wasted complete weekend. Rechecked with built up the wiring from scratch. Same Problem.
Suppose I have swap the cables, which I doubt, why it works when I disconnect it completely?

hello,
very good project!
I currently testing version 1.4b1 and I have a problem. Only if I disconnect the CE line on the sensor, the values ​​are transferred.
If the CE line is connected, only one part will be sent, see Figure 1, the LED on the sensor remains on. As soon as I disconnect CE line, all values ​​are not sent are transmitted (Figure 2) and the LED goes out and lights up briefly in the next transmission.

Does anyone have an idea?

greeting

aqua

Figure1

Figure 2