@heinz
Sorry...everything is fine with the gplot files...it was my fault trying to look at them with the crimpson editor...instead of FHEM gplot

@heinz
Hi Heinz, the SVG_FileLog_Vallox_#.gplot files are empty ...probably the link is dead...could you reup them? Or could you send them tio me?

Thanks, Holger

@alexsh1
in MyConfig.h #define WITH_LEDS_BLINKING" is commented out :(

/**********************************

• Information LEDs blinking
  ***********************************/
  // This feature enables LEDs blinking on message receive, transmit
  // or if some error occured. This was commonly used only in gateways,
  // but now can be used in any sensor node. Also the LEDs can now be
  // disabled in the gateway.

// #define WITH_LEDS_BLINKING

// The following setting allows you to inverse the blinking feature WITH_LEDS_BLINKING
// When WITH_LEDS_BLINKING_INVERSE is enabled LEDSs are normally turned on and switches
// off when blinking

//#define WITH_LEDS_BLINKING_INVERSE

Hello,

I have almost the same error when compiling ValloxSensor:

ValloxSensor:351: error: no matching function for call to 'MySensor::MySensor(int, int)'

MySensor gw(CE_PIN, CS_PIN);

                       ^

Propably the library has changed?

@sundberg84: Yes, there are leds for each of the 4 steps, but I´m prettey sure my wife won´t let me read the leds of the design kitchen hood (novy) :) ... so the sensor has to be placed inside or on the top, where it couldn´t be seen. Some kind of current sensor could do it, but I didn´t find one...

I would like so set my house ventilation to maximum, when the kitchen hood ('Umluft") is turned on. I checkend, if there is a sensor for this kind of question, but i couln't find something. Has anybody an idea?