Topics created by Marcin

It seems that using an Ethernet PHY (like LAN8720) with the ESP32 in a MySensors setup requires a bit of extra configuration, including initializing the PHY using the ETH.h library and disabling the default Wi-Fi initialization. Interestingly, this setup allows for dual IP addresses, with one for the Ethernet connection and another for Wi-Fi, which can be useful in certain applications.

Thanks for the answer. I meant that Mysensors has ESP32 support but only in terms of WIFI. It supports e.g. stm32 with ENC or W5500 modules - and the question is whether and how to add ESP32 support with LAN8720 module. I am not considering using ESPHOME or MQTT - I want to have native communication with the controller that implements my control schemes on its side. I try to program KC868-A16 but it does not matter - the question is whether such support can be added in a simple way.

I found procedure gatewayTransportInit(), it works great. However, I cannot find a procedure that will enable detection of a network connection at level mysensors. I noticed that disconnecting the network plug or resetting the W5500 (37 pin to ground) changes the device's IP address to 0.0.0.0 - then I call gatewayTransportInit() - but mysensor's library must have such procedures - please tell me how to diagnose ethernet connection.

I'm afraid, the MYSbootloader is only available for the AVRs.