MySensors is an EXCELLENT project.
It allows for complete control over the various sensors.
It's extremely simple.
Its drawback is that it's open source, so it's unfunded and development is slow, but I don't think there are any better projects than this at the moment.

@skywatch said in Ebyte nRF24L01P Wireless rf Transceiver E01-2G4M27D 27dBm SPI 2.4GHz Transmitter:

usando problemi qui. Puoi postare

Good evening!! I also fought with some of those modules believing they didn't work, in the end the problem was the power supply !! Get tested now they work.
Here is the scheme I used:

Everything is about providing GOOD Power

I apologize for the bad English

Look, it's true there haven't been many developments, but it's also true that this is a very complete project and at the same time very simple to learn and manage!!
With MySensors, as it stands, you can already do anything. The only limit is your imagination!!
There's really very little that can be further developed... And I don't think other projects allow for the customizations you can do here.

@skywatch said in Go to loop(); when parent/gateway can't be found.:

ai tempo, potresti dare un

Just insert this line:

#define MY_TRANSPORT_WAIT_READY_MS 1000

before : #include <MySensors.h>

this is all, so if the Gateway is not available after 1000 Milli seconds, the scketch is performed anyway

Discovered the problem !! I fed through the "RAW" pin while feeding through the VCC

Ok is now working

This could be for you: https://it.aliexpress.com/item/plastic-outer-shield-for-thermo-hygro-sensor-spare-part-for-weather-station-Transmitter-thermo-hygro-sensor/32793243933.html?spm=a2g0s.8937460.0.0.f3dWg7

you could also provide the links on eBay of the pieces

Excuse me but I go a little OT ..... What dashboard and this are you using?

I got it!! So if I use domoticz as a controller, I should retrieve data from domoticz ...... Okay ???

@mfalkvidd ok now I understand, and then commands an Arduino or other. thank you

@skywatch said in Motion sensor increase Time high status via software:

ti sei

Hello and sorry, if I gave the idea of being courteous !! sorry again
I didn't publish the code because I really don't know where to start, but now that I understand WAIT, that in MySensors and a separate thing, I also understand your example, and I thank you for helping me !!
But then again I didn't know that this WAIT, was something different from DELAY
I answer little, because I'm a little busy these days ..... But anyway for now thanks again for help