new serial gateway
-
Hi,
I had to replace my arduino on the serial gateway and it seems, none of the nodes will connect now.
Do I need to reset them somehow?Thanks and regards,
SJ
-
Most likely no, depends. - what does your log say, and what controller do you use?
-
What does the debug log say. Did you previously change frequency in MyConfg.h?
-
@hek @sundberg84
I did not see anything in the log. I had to restart the nodes and then they found the "new" gateway
-
i had this issue the other day too when i restarted my gateway and controller (Ethernet Gateway powered by RPi Domoticz Controller).
I had to go and find and restart each of my nodes. it was rather annoying.
Is there a way to broadcast somekind of remote restart command? even if the Nodes dont broadcast to the gateway, maybe the Nodes can listen for a restart command?