ESP8266 crashes while starting up and receiving a message from node
-
Hi there,
I have successfully setup a sensor network with MyController, Wemos D1 mini (Mqtt GW) , Arduino and RFM69, and it normally works fine, but sometimes I start Wemos D1 mini, then it immediately crashes, It happens only when a node sends data while Wemos GW is starting up.
I suspect it's happening because gateway tries to send the message to the controller while not connected to the WiFi yet.
Is there a way to not process messages from nodes while gateway is starting up, so gateway would ignore node messages until it's initialised.
-
what version of esp8266 definitions are you using?
1 out of 2
Suggested Topics
-
💬 Bed occupancy detector
OpenHardware.io • 4 Oct 2018, 19:18 • openhardware.io 4 Oct 2018, 19:18 -
💬 Usb serial Mysensors Gateway
OpenHardware.io • 28 Jul 2019, 17:40 • openhardware.io 28 Jul 2019, 17:40 -
Watchdog on 2.0
General Discussion • 11 Sept 2016, 16:10 • CrankyCoder 7 Jan 2017, 11:57 -
Raspberry Pi and MQTT-OpenHAB
General Discussion • 27 Nov 2014, 17:33 • C.r.a.z.y. 30 Nov 2014, 17:59 -
WizNet5100 ethernet module chip temperature
Troubleshooting • 21 Jan 2015, 17:08 • bomber 25 Jan 2015, 22:13 -
Raspberry Pi Zero WH as gateway?
Hardware • 18 Jan 2018, 18:22 • sentur 18 Jan 2018, 20:08
