I have a board setup with a switch and a temperature sensor. When I try to combine the two sketches I get multiple errors.
Can someone take a quick look at combining the two sketches?
I'm having the same / a simular issue of temperature related readings, but at a different temperature level (for me it must be > 14 degree). I massure the dew point as well (temperature = orange, dew point = yellow). It looks to be more related to water in the air than only to temperature.
@zboblamont have you been finally been able to find a solution?
@tbowmo are you still here man?so what is the pin? I also lost my PIN to d3 game controller and I want to get this connected to my phone to play, that's the third step and it won't connect unless I know the pin to this apparently.
https://github.com/mysensors/MySensors/pull/1562 switches to using libgpiod instead of the earlier interface. I have not tested it myself but it looks good.
@tnick STM32F1 2019.12.8 (stm32duino) is the version that was active when the latest MySensors release was made. Later versions may or may not work; nobody would know until they tried.
