iTead Studio iBoard MySensors Edition
-
Hello folks!
Long story short, i've mailed with Jerry from iTead Studio and he said he could create a MySensors compatible iBoard. It seemed like no biggie, in fact, that it wouldn't cost extra, and that he might even sell it to anyone who asks.
These were his words:
Well, it's quite simple change.
We can provide you Mysensors.org version at the same price if you need in small batch.
I shall consider selling the modified version publicly.How's that sound to you? I just think i might ask him for a board or four.
Here's the original one: http://imall.iteadstudio.com/development-platform/arduino/arduino-compatible-mainboard/im120410001.html
-
@Robin-Laurén I would buy one.
-
I could have one or two allso.
-
I might buy four...
-
I will go for two.
-
His minimum order size is 50 units. Maybe if the owners of Mysensors would like to organise something, or if I could make it happen on Tindie?
-
I could do one also
-
You can use the unmodified iBoard with a few simple changes in the pin definitions in the RF24_config.h and the sketch. Use the full constructor (not the shortcut with less parameters that will use defaults for missing parameteres and neglect your definitions).
See my post
http://forum.mysensors.org/topic/224/iboard-cheap-single-board-ethernet-arduino-with-radio/47
-
Nice work Hugo. Ive just ordered another iboard so will try the software method over my h/w one.... but might it still be good to have a mysensors version which also has the ATSHA204 chip integrated....
Also, does anyone have a tricky way to choose a different "RF24_config.h" file when compiling for an iboard and then for a sensor node?
-
My unmodified iBoard is working for months now as a gateway without problems. Initially I had some problems with hanging connections. But these problems disappeared after replacing my 1$ power supply with a 3$ one. The iBoard needs a decent power supply.
