Arduino Pro Mini and Mini W5100 LAN Ethernet Shield
Hallo. I would like to use a gateway based on Mini W5100 Ethernet shield with no Radio module: is it feasible?
I have connected the devices as indicated in MySensor but I cannot reach my Controller (Domoticz over Raspberry PI).
The output of serial debug is
0 MCO:BGN:INIT GW,CP=RNNGA---,REL=255,VER=2.3.1
11 !TSM:INIT:TSP FAIL
10027 !TSM:INIT:TSP FAIL
20044 !TSM:INIT:TSP FAIL
@giangired yes. Just remove the #define for the radio if you don't want a radio.
@mfalkvidd thanks. Removing the define for radio the output says TSP NA, why?
@giangired because there is no transport. In MySensors lingo, transport is how multiple MySensors nodes communicate with eachother. Supported transports are nrf24, rfm69, rs485 and a few more. Since you only have one node, no transport is needed.
Thanks for clarify. So, why my raspberry pi domoticz don't see the gateway? If I try to ping the ethernet gateway i cannot reach it. Ma there any ping test to be used?
@giangired I don't know. Could you share the sketch you are using, the debug output of the gateway, what configuration you are using in Domoticz and the domoticz debug log? Maybe we can help spot what's wrong.
sparky60 last edited by
I am having the same issue using a NANO and Mini 5100. If anybody has some working code, would you please share. I can get everything working if I use a UNO instead of NANO. The NANO and 5100 shows up on my network but is not talking to MySensors. I am trying to integrate into VERA.
@mfalkvidd Solved, it was my mistake on wiring. Thanks.