How control W5500/W5100 (with STM32) by mysensors library
-
I have a problem with W5500/W5100/ENC28j60 and STM32. Each of these ETH modules jams after a few days. STM32 works correctly but has no knowledge of the lack of network connectivity. Is there any way to detect this condition and reinitialize the W5500/W5100 module? To be clear - the modules do not respond to PING.
-
I found procedure gatewayTransportInit(), it works great. However, I cannot find a procedure that will enable detection of a network connection at level mysensors. I noticed that disconnecting the network plug or resetting the W5500 (37 pin to ground) changes the device's IP address to 0.0.0.0 - then I call gatewayTransportInit() - but mysensor's library must have such procedures - please tell me how to diagnose ethernet connection.
Suggested Topics
-
Arduino Celebrates 10 years (Malmö/Sweden)
Announcements • 29 Mar 2014, 17:08 • hek 29 Mar 2014, 17:08 -
Saving last known good state, but not in EEPROM
Development • 30 Jan 2024, 18:46 • OldSurferDude 15 Jan 2025, 08:51 -
PJON and Minicore not working
Development • 27 days ago • Trand 27 days ago -
Radio waking up for no reason.
Development • 4 Jul 2020, 21:09 • Sasquatch 15 Jan 2025, 08:33 -
MQTT-Help me understand about the MQTT Gateway.
Development • 2 Mar 2025, 01:44 • dpcons 12 Mar 2025, 23:39 -
Counting Incoming and Outgoing Messages from a Gateway
Development • 10 Dec 2024, 21:57 • Trand 14 Dec 2024, 20:23
