"Washing machine ended" sensor

  • Hero Member

    @Cliff-Karlsson sorry for the delayed reply.
    It needs to be set just on the verge.... So, turn it slowly until it is 0,give it slight turn back. These sensors do not have good signal amplification (its ok for the price i guess) so they work in a vwry narrow ranfe

  • @Moshe-Livne Thanks for posting this. I definitely plan on trying this for my washer but am curious if you think that it would work for the dryer as well. Is the SW-420 sensitive enough to be able to detect the more subtle movement of the dryer?

  • Hero Member

    @chuckconnors I seriously doubt that. the washing machine has much move violent movements. For the dryer I think I would go with current as it is continuously drawing current (lots of current!) while working. In retrospect I would do the same with the washing machine if it was not under warranty. get a small junction box, expose about 3cm of the cable and use non invasive current sensor, all inside the box. Problem is, as always, power for the arduino.
    another option that I considered is taking a good quality power strip, with lots of space in it and putting the sensor and the arduino inside it or only the current sensor (as the wires are exposed usually inside the strip) and the arduino device and charger on the outside. many modern strips have good quality USB sockets so no need for charger.
    just my 2c... not saying you should touch mains, etc bla bla bla....

  • my machine has an "end" led...so I attached a light sensor (LDR) on top of this led...

    just an idea 😉

  • Great Idea. Ill sure make one of these soon. But I think that I will add two start buttons (one for me and one for my girlfriend) and if one of the buttons is pressed as soon as washing machine is finished domoticz will send pushbullet notification to me or my girlfriend.

  • Hardware Contributor

    Hello, that's a very interesting way of solving the problem, I was planning to "upgrade" the wall plug with an in-wall switch including an ACS 712 sensor, this way it could detect 3 levels no current / low current (= on but not washing) / high current (washing). But this is so much simpler that I have to give it a try !

    I don't see why using a sensor board for this though ? It's just a basic switch so it could be connected to interrupt pin directly without a board, and then it's possible to do battery-powered sensor. I'll try that and give a feedback.

  • @Moshe-Livne are you still using this setup? I tried it but sumtimes I get false readings. Like a notification, while the machine wasn't even on...

    @Nca78 Did you ever do a project with the ACS 712? I was wondering about this sensor en it's safety.

  • Hero Member

    @JahFyahh yes, still using it. I never get false readings although lately I started getting the notifications half way through the cycle. Need to check the glue.

  • @Moshe-Livne how did you setup the sensitivity on the senser. I tried your advice, turning it to 0 (all the way to the left) then one stripe back. I pasted it with double sided tape to the top of the machine. Any other tips? I'm thinking of pasting it to the back of the machine.

  • Hero Member

    @JahFyahh it was mostly trial and error. I was lucky and my initial setup was good but these sensors have very sensitive adjustment (all cheap sensors do, i think) and sometimes a fraction of a turn is enough to change things. I think I wrote a simple "read in a loop" sketch and shaked it a bit (like a washing machine, small shakes) to see if i have a read. Hope that helps. I think top of the machine vibrates a bit more than back. if you put on the back, maybe try to mount it high as the upper part moves more than the lower part.

Log in to reply





Looks like your connection to MySensors Forum was lost, please wait while we try to reconnect.