st=fail on reboot



  • Hi there,
    For some reasons I have to send a reboot request to one of my node (with id:1).

    When I send this message from my controller:
    1;255;3;0;13;
    I got this log from the GW :
    0;0;3;0;9;send: 0-0-1-1 s=255,c=3,t=13,pt=0,l=0,st=fail:
    And I don't have the expected reboot on node #1.

    What st=fail: means ?
    Any idea that can block the node from rebooting ?

    Thx,
    G.



  • Was the node awake and listening? st=fail means transmission to that node failed (no "ok" back).
    If it's battery powered, it's probably sleeping with radio off.
    One trick seen in another thread; after the node has sent data to the gateway, listen for like 200ms for any incoming packets. In the controller; keep the reboot packet on hold until you hear from the node - then quickly send it.


Log in to reply
 

Looks like your connection to MySensors Forum was lost, please wait while we try to reconnect.