SensorID not stored in EEPROM
-
HI all,
I am using domoticz in combination with mysensors. It appears that when I reboot the whole system (gateway + sensors) or sometimes even just the sensors, they are rerecognised by the system. I read that the ID should be stored in the EEPROM, but it appears this does not happen. Anything I can test?
Kind regards
Steve
-
Connect the sensor to your computer and look in the IDE/Serial Monitor. If debug is enabled you should see the node id stored in EEPROM.
-
I rebooted the sensor and now it does store the sensorID. (Could this have been as I was on 1.6.5-R5 and now on 1.7.7 or the IDE?)
1 out of 3
Suggested Topics
-
Update RF24 library to latest version
Bug Reports • 23 Mar 2014, 23:37 • andriej 24 Mar 2014, 22:52 -
No merge into master in the last 5 years, should we use development?
General Discussion • 23 Sept 2024, 17:48 • kiesel 3 Oct 2024, 14:18 -
What's a good power bank for use with IoT?
General Discussion • 14 Dec 2021, 17:28 • NeverDie 17 May 2024, 15:03 -
single-click, double-click, long-press button possible with MySensors?
General Discussion • 4 Feb 2024, 08:28 • dirkc 4 Feb 2024, 11:18 -
GatawayESP8266 - Compile error
General Discussion • 18 May 2021, 11:50 • skom 5 Jun 2024, 15:55 -
Old hardware migration
General Discussion • 29 Feb 2024, 03:43 • dbemowsk 1 Mar 2024, 23:03