Arduino Nano + NRF24L01 in single side PCB



  • Hey I'm completly new to PCB making. I etched my first PCB with an arduino nano plus an NRF24L01 module. I couldn't route all the traces and ended up using one jumper wire.

    Is it possible to route a connection between those two components if you are using a single side PCB with big traces (basically I don't want any traces between pins) ? Has anyone done anything like that? I mostly used the eagle autorouter and then tried to do it by hand but failed miserably, but I'm a noob and this and maybe missing the good tricks!

    0_1474384261700_Capture.PNG


Log in to reply
 

Looks like your connection to MySensors Forum was lost, please wait while we try to reconnect.