Hi all,
Should anyone face the same problem, I found the root cause: brownout threshold. I burned a new bootloader (Optiboot 8.0) without such trigger and the node has been working with used batteries (~2.7V) since May.
Hope this helps.
Hey vivek101
how did you connect the NRF24L01 to your home assistant server? Normaly, you connect the nRF to an microcontroller and flash it with a gateway sketch. Then you connect the uC to your server...
Regards, Edi
Not yet !
In fact, the interrupt must be short enough and fast enough to be sure to not miss the RFM69 interrupts.
The code for 8 dimmers will not be really more complicated : in fact, each time we got a zero cross, we must set a timer to zero, and then wait the good amount of milliseconds to turn on the needed outputs.
So, yes, we'll have an interrupts each 10ms (each time the wave crosses the zero, to be precise !), but I think all we have to do in the interrupt handler is set the timer to zero (or to micros() ...) and then on the main loop, wait the good amount of time for each output before setting them ON.
Seems simple on paper, perhaps it will not work on the chip....
In facts, my main concern is : will the RFM interrupt be short enough to not disturb the zero crossing interrupt ?
Although, not yet tested the RFM : do we NEED the interrupt pin ? Can't we poll frequently the RFM?