Topics created by meanpenugin

@hek said: You can do a simple msg.isAck() in the message callback to check if it is a ack message. How the received acks can be matched with the sent messages?

No there isn't any easy way to broadcast to the entire radio network. The problem is to send messages to nodes that requires a repeater-node in between to be reached.

Finally began tinkering with the boards I ordered a couple of months ago. Built 2, using regulated 5V. Both tell me they cannot init radio. I have yet to pull out the multimeter and begin diagnosing, but wanted to post up and see if anyone else has experienced this? I have not actually come across this error before with MySensors. I did solder pin 1 and 2 on the two pads, attached a 5v to 3.3 volt step down, cap in the slot direct above the radio. Blanking on what could be wrong, other than something witht he baords I received.

@meanpenugin This will be changed. Thanks.

Won't be eras nor years