Home Assistant

This is on my todo list. I hope to get to it soon.

Please post your json persistence file.

I bought them on aliexpress from the cdebyte shop. There are a few open topics about real and fake nrf24 if you want to read some more. As a general rule of thumb consider that the genuine nrf24 chip is normally sold around 1.2$ so you can't buy a fully assembled genuine module for less than a dollar.

@gohan said in MySensors ethernet 2.2.0 problem with control node switches: send(msg.set(RELAY_OFF), false); // notify controller to show off state ok looks that is ok but please give me a time i test it more.

Hello, I'm using hassbian, and to edit .json, prior to that, I just stop homassistant , edit file, save file and start homeassistant service again... all working..

But control switch relay not woking on my MySensors 2.2.0... I describve it in other topic: link text

I have similary problem... https://forum.mysensors.org/topic/9046/mysensors-ethernet-2-2-0-problem-with-control-node-switches Anybody can help me please ?

@antonholmstedt If a node is unknown it means that it hasn't sent proper presentation messages. A debug log from home assistant and a serial log from the node in question might shed some light. Usually this problem comes from messages not reaching the gateway.

Thanks for the pointer obvious in hindsight!! So problem fixed after looking at the issue log on github here. Seems that this is a known feature/ problem of the library/ nrf24. Basically if your trying to send messages via the radio one after the other you need to wait for gateway to respond/ process before sending the next message. If you don't you will get intermittent results which mirrors my problems with presentation, messages and battery. There are some good conversation on how this might be fixed under version 2.2 or not but for the simple solution has been to implement the solution proposed by user trlafleur - its simple, works and I don't have to start messing with dev libraries (which I dont have a clue on)

You likely need to load the "ClearEepromConfig" sketch to the arduino to clear all of the data from the arduino.

Hi there, I'm resuming this old topic 'cause I'm trying to make a dockerized version of MySensors gateway, built on a debian image. It compiles easily, but I'm stuck on transport initialization. No one tried it? Since I'm quite new to this, I can't give now a github link, but I'll do ASAP, so we can collaborate on this.

No mysensors devices will be visible in home assistant until they are presented and send their first values to home assistant. So only having a gateway without sensors will not generate any mysensors entities in home assistant. You can read more about presenting your mysensors devices to home assistant here: https://home-assistant.io/components/mysensors/#presentation

I made a pull request over on github, if @martinhjelmare accepts it we should be good to go.

You can't do it on an arduino. Since you are going to run a controller it could make sense having a raspberry. Running 2 separare instances it would not be a problem for HA as you would have to add the 2 gateways anyway like if they were on separate hw

damn i think i found the issue, the presentation uses V_TRIPPED, that should be S_MOTION or S_DOOR, gonna try that tommorrow update 21-11, it indeed was the V_TRIPPED vs S_DOOR.

I'm an idiot....... I just noticed a binary_sensor.nodemanager_113_3 was created in the dev-state page.

you can use https://jsonformatter.org/json-editor to edit json data.