Voltage Follower Help Needed
-
Does anyone have any experience regarding voltage followers?
I'm looking at implementing a voltage follower into my Electrochemical Sensor circuit for Carbon Monoxide and to remove any electronical noise that could influence the sensor (which its very sensitive too) they recommend i add in a voltage follower before the sensor output gets to the OP AMP to the MCU.
Page 6 of the datasheet shows the voltage follower circuit proposed, but my current circuit is using a non-inverting setup where the proposed schematic (shown below) is using an inverting method. I know that the voltage follower is a non-inverting OP AMP itself, and i know how it works by utilizing the fact no current can flow through a OP AMP, however i just do not know/understand how to use this in my current setup.
How would you go about implementing the voltage follower into my current circuit? Is it even possible to have a voltage follower on a non-inverting setup?
Voltage Follower Circuit
My circuit
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login