Need some help with this sensor setup for RF remote
-
Hi.
This is my first post so sorry if this is in the wrong section.
Im thinking of doing a RFM69/arduino mini pro remote to have some WAF to my sonoff switches.
The RF remote will have 4 buttons that in the end will turn on some sonoff switches in my apartment.My question is, when the arduino and RFM69 is in deep sleep state, how long will it take for the "remote" to power up and send the button pressed message to the gateway? To have some sort of WAF my thinking is that this need to be lower then 1 sec. Is this possible?
And if you have any suggestions please feel free to say them!
Best Regards
Brew8it
-
@brew8it the wake up time for atmega328 is about 70 milliseconds. Time to send a message is normally a few milliseconds. So total time should be below 0.1 seconds.
-
-
RFLink to your controller plus 4 button RF senders from ebay.
Suggested Topics
-
Over the air updates
General Discussion • 23 Mar 2014, 21:38 • ToSa 1 Mar 2015, 11:21 -
Best VOC sensor for detecting a wide range of VOC's?
Hardware • 26 Oct 2023, 23:59 • NeverDie 18 Nov 2023, 01:41 -
Best time of year to buy higher quality small project solar panels?
Hardware • 10 Jun 2021, 19:19 • NeverDie 30 Aug 2024, 14:01 -
Arduino Nano Every problem
Hardware • 1 Feb 2020, 09:18 • hakha4 5 Dec 2023, 02:21 -
hlk-pm01 are to noisy for rfm69?
Hardware • 5 Aug 2023, 21:16 • Tmaster 9 Aug 2023, 16:28 -
"Remote Irrigation with LoRaWAN: LM27313 Challenges and PCB Design"
Hardware • 24 Jan 2024, 23:06 • wrendral 3 Feb 2024, 07:13