Extrenal contact from water valve on same child-id



  • Hello MySensors friends,

    I made a node to control a water valve, the valve has its own status contact which I use as status signaling in the controller (Domoticz) of the valve,
    The contact uses the same child ID as the control of the valve, in MYScontroller I see that this works well, I send the valve open, if the valve is open the status will also be set to 1, so exactly as I want it .

    Only within Domoticz does the status of the control change immediately when the button is pressed, and when the valve is open I see the status getting a trigger again, so the berict will certainly come through.

    In the Domoticz hardware settings I have already disabled ACT from this child ID.

    Does anyone know how I can adjust this so that the status does not change until the valve has actually changed position?

    Thank you in advance

    dzjr


Log in to reply
 

Suggested Topics

  • 5
  • 1
  • 4
  • 8
  • 2
  • 2

0
Online

11.4k
Users

11.1k
Topics

112.6k
Posts