@canossa Sorry for the late response.
yeah, since is so compact and you can get it for relatively cheap I opted in for the NRF52.
For home automation, I merged MySensors with Domoticz and it works for months now.
https://forum.mysensors.org/topic/7836/what-did-you-build-today-pictures/738
@jocke4u I run 2 RF gateways and it's not a problem. When you 'migrate' a node to a new gateway make sure to run the mysensors clear eeprom sketch first to get rid of the old routing table or you might have issues.
Finally I've solved. I'm still using UIPEthernet sincee my problem was the use of DHT library (last rev) with UIPEhernet lib.
I was having a restart of teh ETH port each time I was reading Temp/hum. I've changed into SimpleDHT lib and now it's working fine. I'm using a mix of W5100 and ENC28J60.
@OldSurferDude use a host name for the broker in the configure command (--my-controller-url-address=). Add the host name to /etc/hosts on the rpi where the gateway is. Start the MySensors gatway.
When you want to switch brokers, modify /etc/hosts again and restart the MySensors gateway.
