I have a board setup with a switch and a temperature sensor. When I try to combine the two sketches I get multiple errors.
Can someone take a quick look at combining the two sketches?
You write "...clicking is heard..." Is that a single click or a click click click ...?
After getting the LOW signal, wait a period of time and if it's still low, send the message that there is a flame. Likewise for a HIGH signal.
Perhaps instead of a relay, an opto-isolator?
@jaydenlord Probably you do. If you leave the EN floating, electrical noise could cause it to enable or disable randomly.
Some enable pin require a HIGH, some LOW. Connect it to VCC to see if it works more consistently. If it doesn't detect, connect it to GND.
If one of these works, then the part wasn't designed to be in a default state of enable.
Let us know your results (I found this video
OSD
I'm having the same / a simular issue of temperature related readings, but at a different temperature level (for me it must be > 14 degree). I massure the dew point as well (temperature = orange, dew point = yellow). It looks to be more related to water in the air than only to temperature.
@zboblamont have you been finally been able to find a solution?
@tbowmo are you still here man?so what is the pin? I also lost my PIN to d3 game controller and I want to get this connected to my phone to play, that's the third step and it won't connect unless I know the pin to this apparently.
