@Newzwaver All hardware except 433MHz antenna is from MySensors "Store". I found the antenna on ebay and the box for everything is bought here in Sweden (http://www.kjell.com/se/sortiment/el/elektronik/elektroniklador/ventilerad-inbyggnadslada-95x135-mm-p89012)

@olaeke I would think you may be pushing it. Any way to use a few separate supplies for a short time to see if that helps? If you decide to just upgrade your supply, you may want to put caps on the radios to help stabilize the bus.

@korttoma Hey Tomas, thanks! That seems to have worked. I'll update if there is a problem. Other than this issue, I think UI7 is OK for me (testing in one location only :) )

Hi everybpdy.....any news on this topic? my radio chips say NRF24L01+, however are detected as NRF24L01. Got 3 of em working perfectly on Uno and Nano...but on pro mini always gettin the f**n "check wires" message...the only difference is the regulator (I'm using arduino pro mini 5V), but i checked and radio is getin 3.3 as it should be.

@anjo This is just what I'm trying to do - without success. I'm nut sure it it's a HW or a SW problem, but I have being using MySensors before. Did you do anything special on the Edge?. I'm out of idears - I have the same Ethernet board, a NANO and the radio - have double checked wiring and enabled softspi in the lib. What was your main problems? /Kurt

Thanks but that thread ended on the difficult part: "please, help to send the presentation string when inclusion mode has been triggered" Anyone have a idea about this? It would be easier to include one more Arduino and a radio but the hardware and programming is one of the fun part with MySensors Regards