@mfalkvidd thanks, I was wrongly under the impression that sudo mysgw would show the logs but it creates a second instance. Thanks for helping :smile:!

@monte seems to do the trick :grin: thanks again!!

@nca78 appreciate the elaborate answer, thanks!
Regarding NDIR sensors, how frequent do they need to be recalibrated to maintain accuracy?

@sineverba thanks, I got it working and it's up and running. Still have to desolder the led and remove the regulator, will do that later.
Regarding the BOD, what happens if I disable it? Will it run for longer as it does not shutdown? Or is any voltage below 1.8v bad for the arduino?

A bit off topic maybe, but I was wondering how the 'pros' around here make the sensor small and sturdy for Arduino's with Si7021+ 2xAA battery pack. My DuPont wires seem a bit loose, so I'm wondering whether I should solder them. And perhaps someone 3d printed a case for an Arduino+Batterypack or some sorts.

@krabbi I have a similar issue as un4 described.
When nWake is connected on GND it works fine, when connecting to D3 (6) it stops working. I'm using the same sketch source as krabbi. Any suggestions?

@niclas hey man it seems to be working due to putting the version in the config file, at the right indent. So your suggestion worked after all, guess I had to wait a bit before it was recognised by HA. Thnx, problem solved :smiley: