#define MY_DISABLED_SERIAL not stopping all serial data

[delinend]

It looks like, that the #define MY_DISABLED_SERIAL not is stoping all serial data, from showing up on the serial port, on my GatewaySerial.ino.

I have used:
//#define MY_DEBUG
#define MY_DISABLED_SERIAL
.
.
void setup() {
Serial.begin(115200);
}

But I have a temperatur sensor, that is sending data, to my GW, and it still show data on my GW serial port.

Ex. temperatur from NODE 6:
6;0;1;0;0,24.5
6;0;1;0;0,24.6
6;0;1;0;0,24.5
6;0;1;0;0,24.4
6;0;1;0;0,24.5

How do I stop this, so that I can use my serial port, on the GatewaySerial, to other things.
Btw. I only want to "grab" data, via the "void receive()" function.

My setup:
Last Mysensor 2.0.1-beta
2 Arduino Mini Pro (8Mhz) 3.3V version
2 NRF24l01+ with 47uF caps
Use a 3.6V LiPo battery on both setup's.
IDE 1.6.12

[hek]

The whole purpose of the serial gateways is to output incoming messages on the serial line.

Why not create a none-gateway node?

[delinend]

@hek
I was thinking of the same. Can you put me in a direction of an sketch, that I can use for that ?

[mfalkvidd]

Why not create a none-gateway node?

Or at least a non-serial gateway. Like ethernet gateway or mqtt gateway.

[delinend]

@mfalkvidd
Dose it has to be a Gateway to "grab" the incomming data, from my sensor, or just a RepeaterNode ? Like a Sensor->Repeater only setup ? Have tryed this, but can't get it to work.

[mfalkvidd]

@delinend a gateway sees all messages in a MySensors network. A repeater sees all messages passing through it. A node sees all messages sent to that node.

[delinend]

@mfalkvidd
So before 2 NODE's only setup, can talk together, I have to remove the REGISTRATION_FEATURE ?

[delinend]

@hek
Can 2 NODE's talk together, without a Repeater or a Gateway ? I have tryed many things, but I can't get any data in the void receive() I use the #defined MY_TRANSPORT_DONT_CARE_MODE, and the MY_PARENT_NODE_ID and MY_PARENT_NODE_IS_STATIC command setup (NODE ID 6 and 7).