Powering a transiver without external antenna?
-
Hi quick question. Is it dangerous to power a transiver like the one in the picture with external antenna when the antenna is removed?
I have solderd the transiver to the arduino and need to program the arduino but I dont have the antenne here.
I belive that in some cases you can fry the transiver. What do you think?
-
@popunonkok just powering it will not brake it, but I wouldn't try transmitting with it. If you flash a mysensors sketch in it and start it, it will start transmitting immediately, so be careful!
-
But dosent it start the sketch directly after I flash it?
-
@popunonkok said:
But dosent it start the sketch directly after I flash it?
Depends on how you flash it, I guess.
Your original question was: "Is it dangerous to power a transiver like the one in the picture with external antenna when the antenna is removed?" so I tried to answer that.
-
Yes I understand. I'm not criticising your answer. But I guess that means that I cant program it at the moment. Because that would mean the transiver would start transmitting directly.
Hmmm... Unless I start with a 5-10 sec delay.
It is a temperatur sensor sketch. I could probably code a 10 sec delay in the void setup() section. It would be an ugly solution but probably would work.
-
@popunonkok - unless you connect a normal radio to test.
