Hello,
I'm doing the Ethernet getway, but I have a problem.
I would like adding a a button to sync the sensor.
Someone know how I do this?And of course add button in sensor to sync the devices.
Thx
The output of the display could also be sent over serial, but the whole idea is you can walk around with the doctor and improve your results as you go.
@adds666 I'm not sure but I believe Domoticz prresents it's dimmer values in steps from 5 to 100 I believe. It'd about 10 steps. That's why I'm not sure if you can add more patterns. Unless you indeed change it to a percentage. Hope it helps
@DeepCore That is a need looking design. Did you consider using an alternative power supply other than usb? My Pi can't handle a lot of usb devices power wise, so I'm using a powered usb hub. But the wife doesn't like it, it's messy xd
@pbw a gateway's function is to act as a gateway between the nodes and a controller. I don't think you will have all of the needed memory available to add logic to the gateway and you will make your solution very static.
You can implemented your own lightway controller, just have a look at the Serial API. But controllers like Domoticz are lightweight and the already over a browser based interface. And most of them are easy to setup creating a much more versatile and dynamic solution.
Hello everyone,
Firstly, I apologize for reviving such an old thread, but I find myself in a unique situation and was hoping some of you might be able to help.
I hope everyone's doing well. I have a specific inquiry that I couldn't find a recent solution for. Does anyone here know of a tool to generate "fake" Dooya remote (DC90) RF codes for curtains? I've acquired a few motors without controllers and am trying to integrate them with Home Assistant and Bradlink RF remote. Specifically, I'm searching for a way to generate codes for the Up, Down, Stop, and the "Set" button functions to configure curtain limits.
Any insights or guidance would be immensely appreciated. Thank you so much in advance!