SenseBender stops reporting data to Domoticz
-
Hi,
i have some problems when using domoticz together with an Ethernet gateway and the sensebender micro board. when reprogramming the node it works for some hours. Then suddenly it stops and no more data are reported. In downloaded the MYSController to check the traffic. In this tool I can see that data are sent all the time but still no data are detected by the Domotic server. I am very confused by this behaviour. Any hints on how to overcome this problem?
/Thomas
-
@gravis12 Can you elaborate a little on the kind of data you are expecting in Domoticz? and (or) a serial log of the sensor?
-
Hello,
I am expecting to see the updated temperature and the updated humidity values. Attached is a picture with the log from the myscontroller beside the log from Domoticz at the same time. As shown the values are received by the Mys controller but no updated data are seen in the log files in Domoticz. Confusing...
-
Is it normal that is says "RFXcom" in the log for MySensors stuff?
-
@hek Nope, it should be MySensors... look at the hardware settings...
Suggested Topics
-
Vera Gateway Versions
Troubleshooting • 29 Mar 2014, 19:59 • karenbobiv 30 Mar 2014, 07:20 -
Blockley in Domoticz-not working correctly. Anyone know how to fix.... ?
Domoticz • 15 Nov 2021, 23:07 • Bren 21 Nov 2021, 18:09 -
How to get the bad status (red) for Temperature Node
Domoticz • 3 Nov 2021, 10:14 • giangired 15 Nov 2021, 07:20 -
S_GAS, send and request problem
Domoticz • 28 Nov 2024, 05:38 • Marcin 28 Nov 2024, 05:38 -
Node update on value from Domoticz
Domoticz • 30 Jul 2023, 19:19 • zboblamont 7 Aug 2023, 14:33 -
eventsystem: problem writing file
Domoticz • 27 Feb 2022, 00:11 • Feliw05 27 Feb 2022, 17:50