I have been trying to figure this out all day.
everything works it just reboots over and over all the time.
see the attached picture for a example.
thanks for any help guys
I'm having the same / a simular issue of temperature related readings, but at a different temperature level (for me it must be > 14 degree). I massure the dew point as well (temperature = orange, dew point = yellow). It looks to be more related to water in the air than only to temperature.
@zboblamont have you been finally been able to find a solution?
@tnick STM32F1 2019.12.8 (stm32duino) is the version that was active when the latest MySensors release was made. Later versions may or may not work; nobody would know until they tried.
You write "...clicking is heard..." Is that a single click or a click click click ...?
After getting the LOW signal, wait a period of time and if it's still low, send the message that there is a flame. Likewise for a HIGH signal.
Perhaps instead of a relay, an opto-isolator?
@mvader Turn the time delay adjustment preset on your PIR module to the minimum.. Now try it.. You will not get a continuous output..Also, prepare the circuit using a long wire from the back to the sensor of your module.
