@Nca78
Well, for small potted plants, you might have to re-pot the plant. However, the nice benefit that would arise is: no visible sensors, which carries with it very high WAF.
To provide a large enough pulse to drive the ceramic transducer , you need a lot of energy, so they pump up the 5v with an inductor/transformer to provide a high voltage pulse. This is 60v or more…
The more Energy you produce the farther the pulse will travel….
Everything thing else on the board run at 3.3 to 5V.
Add a large Capacitor of 100 µF are so between the 5v and ground on the device, this may clean up your problem.. Some CPU modules just can’t supply enough current quick enough that’s needed when the pulse is triggered.
These are very inexpensive device, we’re luck to see them work at 1/2 the spec range.
Hi @chey, no, with the pro minis and MySensors lib I couldn't get less.
Didn't measure with yet another multimeter though...
My battery sensors are working now for about a year and the battery levels are between 65% and 70%.
The sensor furthest from the gateway is at 65% and the 3 others at 70%.
Not bad I think.
https://forum.mysensors.org/topic/11499/checking-mechanical-locked-doors-by-a-battery-based-windows-door-sensor-node
Finally solved a lot of problems and checked a lot of mistakes. But now the first version of this device works almost properly :trollface:
I will make a small report in the description asap
