make erring out on raspberry pi 2 b

[mrhutchinsonmn]

I am attempting to set up homeassistant with a mysensors ethernet gateway on the same raspberry pi 2 b. However, make is erring out. Do I need an older mysensors library?

[SECTION] Detecting target machine.
  [OK] machine detected: SoC=BCM2835, Type=rpi1, CPU=armv7l.
[SECTION] Detecting SPI driver.
  [OK] SPI driver detected:BCM.
[SECTION] Gateway configuration.
  [OK] Type: ethernet.
  [OK] Transport: rf24.
  [OK] Signing: Disabled.
  [OK] Encryption: Disabled.
  [OK] CPPFLAGS: -march=armv6zk -mtune=arm1176jzf-s -mfpu=vfp -mfloat-abi=hard -DMY_RADIO_RF24 -DMY_GATEWAY_LINUX -DMY_DEBUG -DLINUX_SPI_BCM -DLINUX_ARCH_RASPBERRYPI -DMY_PORT=5003 
  [OK] CXXFLAGS:  -std=c++11
[SECTION] Detecting init system.
  [OK] Init system detected: systemd.
[SECTION] Saving configuration.
  [OK] Saved.
[SECTION] Cleaning previous builds.
  [OK] Finished.
root@rpi2-20230102:~/MySensors# ^C


root@rpi2-20230102:~/MySensors# ^C
root@rpi2-20230102:~/MySensors# make
gcc -MT build/hal/architecture/Linux/drivers/core/config.o -MMD -MP -march=armv6zk -mtune=arm1176jzf-s -mfpu=vfp -mfloat-abi=hard -DMY_RADIO_RF24 -DMY_GATEWAY_LINUX -DMY_DEBUG -DLINUX_SPI_BCM -DLINUX_ARCH_RASPBERRYPI -DMY_PORT=5003  -Ofast -g -Wall -Wextra  -I. -I./core -I./hal/architecture/Linux/drivers/core -I./hal/architecture/Linux/drivers/BCM -c hal/architecture/Linux/drivers/core/config.c -o build/hal/architecture/Linux/drivers/core/config.o
In file included from /usr/include/stdio.h:864,
                 from hal/architecture/Linux/drivers/core/config.c:23:
/usr/include/arm-linux-gnueabihf/bits/stdio.h: In function 'vprintf':
/usr/include/arm-linux-gnueabihf/bits/stdio.h:40:1: sorry, unimplemented: Thumb-1 hard-float VFP ABI
   40 | {
      | ^
make: *** [Makefile:103: build/hal/architecture/Linux/drivers/core/config.o] Error 1

[OldSurferDude]

@mrhutchinsonmn I'm not an expert on this code and when I get into a situation like yours, I suspect a corrupted file. So I download the MySensors code again.

Yeah it's a pain because you have it all configured. To minimize that pain, I create shell script to run the the configure program. I also keep my source files in a different directory from MySensors. When I go to compile the code, I copy the source(s) to the directory(ies) to where "make" expects it(them).

Sometimes, for me, I've bolluxed things so badly that I reimage the RPi and really start over! I try to document exactly how to start over.

I admit, it's not efficient nor elegant, but I eventually I get a configuration with which I can live. Documenting what I do is key!