@Ron said in Capacitive Soil Moisture Sensor:
@Puneit-Thukral Thanks. I am not quite sure, so correct me please if I am wrong, but I think I am already using the MiniCore bootloader with platformIO. Or do I need to configure to explicitly use the MiniCore bootloaders? Also I have set BOD to disabled as I read somewhere that no BOD can also save battery.
hi
I'm not sure, but I believe I'm already using the MiniCore bootloader with platformIO. Please tell me if I'm incorrect. Is it necessary to set the MiniCore bootloaders explicitly?
@bisschopsr said in BlackCircle Sensor - High "WAF" Temp/Hum. sensor:
Hi All,
Like the design thinking of this, although an older topic I did manage to get me one of these dishes. After taking it apart, I have one question that came to mind. Is the ventilation in the dish enough for the humity sensor? Is there any experience with that after running this sensor for a while?
Thx
Ralph
Hello, yes I think it's enough, in fact there's much more ventilation than in many commercial sensors which only have a small hole. But it's a good test to make, I'll try to compare to a sensor out of it's enclosure to see if there's significant difference or delay.
@antonholmstedt a pro mini fits if you cut the corners, check out https://forum.mysensors.org/topic/6612/door-sensor-remix-of-some-mys-community-efforts
Very useful topic for me, thanks. Even though it's been a long time, the information was useful to me. And especially the information on the link you sent.
@kimot I am not handling that situation. I'm taking for granted ssr will do his job. Maybe there's some ssr safety topic I'm unaware? Suggestions for a v3.0 are welcome.
About the temperature measuring... I use two sensors. The one in the board protects electronics from temperatures beyond design (60°C). It's near the ssr because the ssr's derating curve is the most limiting condition.
The control sensor is placed in the bottom of the heater. It connects to the board through a 3 pin header connector.
