@Jonathan-Roberts said in Simple AC/DC Switch WeMos:
@nca78 bummer. So I think 2 options...
What if the Wemos is raised off the PCB. That would be almost 5/8". In your experience would that help?
And maybe the best option, slide the antenna module straight down,. move the relay up and spin it around so the connections are on the outside edge.
I'm trying to make this multi-purpose and allowing both headers to be fully functional to other projects. thx for the advise.
1 would help but not that much. It's already not a good thing to have the transformer just next to it on the side, so you should avoid blocking one more direction with tracks.
I don't understand your necessity to have connectors available for something else on the relay that is too high to put anything on top ?
2 sounds like a much better option, make sure you have nothing right and left of the antenna when you move things around.
The problem you will have with this layout is the USB in that situation...
It doesn't sound like a great idea to me to use Wemos on this board especially for the relay part, it's just a cheap chinese relay with 3/4 components so why not just put them directly on you board to make the layout so much easier ?
I have the feeling that you're trying to make things "easier" by using Wemos and its shields, but in the end you seem to lose more than you gain. And neither does it seem "safer" to use their relay shield as it forces you to have extra wires between main of the HLK and relay shield connector.
Hello, i'm making some progress; received the components this week.
Unfortunately it doesn't work... yet
For now i have SanityCheck failure in to logs.
I'm afraid my soldering of all these little components is not good. I tested with a multimeter the 4 pins and i have continuity on one of them but maybe not the others so i guess i will have to try remelting all these small regulators ???
Thanks again, learned a lot... I decide to give a try there, I also had a look on some components' datasheet and seems to be what I need... Let's see, if end up getting the boards I'll publish a review here later.
@acb
Hi @acb and others, regarding "Do you know if there is a version of this board that is pad-compatible with the C-versions of these HopeRF RFM69s before I go searching? (Since I believe the C-versions are also pad-compatible with the RFM95sā¦)" - did you find any alternative?
I'm in the same boat looking for an adapter from NRF24 to the footprint of RFM69*C = RFM95/96.
Thanks, Joost
