@scalz said in HALO : ESP32 multi transport GW/Bridge for Mysensors:
the webapp was great, but I converted it to native crossplatform app for better versatility&perf, so I can use one app for my devices, like Ethernet for HALO etc, or Serial for my other Janus gw dongle, bluetooth..
To be honest, I've not updated anything yet for a few reasons, like very little spare time for a public release + support for such "big" project. (easier to handle local projects).
Sorry, still no eta for the moment..
It is clear that there is not enough time. But this project can become popular. That's what's missing MySensors. ...This void must be filled.
Hi PJR,
now it is working with this code in the MyTransportRS485 without any changes on MySensors.h:
#if defined(MY_RS485_SWSERIAL)
SoftwareSerial& _dev = MY_RS485_SWSERIAL;
#elif defined(__linux__)
SerialPort _dev = SerialPort(MY_RS485_HWSERIAL);
#elif defined(MY_RS485_HWSERIAL)
HardwareSerial& _dev = MY_RS485_HWSERIAL;
#else
AltSoftSerial _dev;
#endif
As far as I can interpret the peace of code, the
#include "hal/transport/MyTransportRS485.cpp"
is active as soon as the MY_RS485 layer is defined.
This is a great step, I can use all my nodes from now on!
Thank you very much for your support!
By Kduino
@kimot I am not handling that situation. I'm taking for granted ssr will do his job. Maybe there's some ssr safety topic I'm unaware? Suggestions for a v3.0 are welcome.
About the temperature measuring... I use two sensors. The one in the board protects electronics from temperatures beyond design (60°C). It's near the ssr because the ssr's derating curve is the most limiting condition.
The control sensor is placed in the bottom of the heater. It connects to the board through a 3 pin header connector.
