How can I load Adafruit NRF52 bootloader on custom nrf52 board with Serial Programming.



  • Hi,

    I hope you are doing well. I need help in understanding how can I program custom nrf52 board with Arduino IDE. After searching internet I know that I need to first flash adafruit boot-loader through Jtag. And then I can use serial to usb connector to program the chip.

    But I am confused between pins used, any softdevice conflict. Did any one tried this? Can anyone one give me steps to follow so I can follow directly and do task.

    I will be thankful for any guide or tutorial.

    Looking Forward,
    Khawaja



  • I'm not familiar with the Adafruit bootloader. Going to have to take a look at that.
    For use with MySensors, you don't use a softdevice.
    Take a look at this thread if you haven't already:
    https://forum.mysensors.org/topic/9266/guide-nrf5-nrf51-nrf52-for-beginners


Log in to reply
 

Suggested Topics

  • 87
  • 8
  • 1
  • 7
  • 7
  • 5

0
Online

11.2k
Users

11.1k
Topics

112.5k
Posts