ESP8266 crashes while starting up and receiving a message from node
-
Hi there,
I have successfully setup a sensor network with MyController, Wemos D1 mini (Mqtt GW) , Arduino and RFM69, and it normally works fine, but sometimes I start Wemos D1 mini, then it immediately crashes, It happens only when a node sends data while Wemos GW is starting up.
I suspect it's happening because gateway tries to send the message to the controller while not connected to the WiFi yet.
Is there a way to not process messages from nodes while gateway is starting up, so gateway would ignore node messages until it's initialised.
-
what version of esp8266 definitions are you using?
2 out of 2
Suggested Topics
-
Unable to pair
Troubleshooting • 3 Oct 2020, 09:16 • Tomáš Mengler 13 Oct 2020, 08:03 -
Is MQTT Necessary? or, Use Case for MQTT?
Controllers • 28 Mar 2016, 01:12 • TRS-80 9 Jan 2020, 09:01 -
Multiple virtual nodes on a gateway
Troubleshooting • 7 Feb 2019, 16:00 • pvoj 12 Feb 2019, 23:14 -
Hello, Can you help me? LDR Sensor
Development • 26 Nov 2016, 23:46 • Nathan Matos 29 Nov 2016, 04:34 -
💬 MySRaspiGW - MySensors Raspberry Pi GPIO Gateway
OpenHardware.io • 17 Jun 2016, 08:02 • openhardware.io 11 Jul 2017, 21:11 -
MySensors MQTT 'dialect' optionally Homie
General Discussion • 5 May 2021, 13:46 • Peter Loeffler 18 May 2021, 13:36 -
Can't get message from OpenHab to MySensor
OpenHAB • 26 Jul 2016, 05:30 • A Former User 27 Jul 2016, 04:58
