MySensor constructor should accept serial device or stream object
-
On my Arduino Uno the only available HardwareSerial is used by MySensor for printing log messages. It would be nice, if the serial device that MySensor uses, (or at least a stream object) could be passed into the MySensor constructor. Then I could use Serial where the uart-buffer is useful e.g. RS485 communication and pass for example an AltSoftSerial instance into MySensor.
-
what about a MEGA any any of the 3 other UARTs?
I see them for under US$ 12.00 on eBay...
-
You are right, that is a possible solution for my problem. I think changing software should be favoured over changing hardware.
1 out of 3
Suggested Topics
-
FTDI/Serial or USB?
Hardware • 7 Apr 2016, 13:48 • Samuel235 9 Apr 2016, 22:01 -
PiGatewaySerial doesn't write to virtual serial device /dev/ttyMySensorsGateway
Troubleshooting • 5 Nov 2015, 16:46 • Michele Rappazzo 5 Nov 2015, 20:43 -
Sending serial commands to sensors
Controllers • 11 May 2015, 16:58 • Tango2 11 Jun 2015, 10:42 -
Trouble with 115200 baud on 3.3V/8MHz Arduino, like Serial Gateway. Solution: Change baudrate.
Troubleshooting • 1 Jun 2015, 20:00 • Stric 3 Jun 2015, 05:21 -
💬 Arduino Serial Gateway for RFM69HW
OpenHardware.io • 24 Jan 2017, 12:49 • openhardware.io 8 Jun 2017, 10:06 -
Can't send message over arduino serial monitor
Troubleshooting • 11 Dec 2014, 05:53 • botbite 28 Jan 2015, 20:55
