I successfully worked around the issue by updating the /Library/Application Support/Perceptive Automation/Indigo 2022.1/Plugins/MySensors.indigoPlugin/Contents/Server Plugin
/plugin.py script to recognize the internal 21 code.
Here's the diff:
34c134,135
< "GATEWAY_READY" : [14, "Gateway ready", ""]
"GATEWAY_READY" : [14, "Gateway ready", ""],
"DISCOVER_RESPONSE" : [21, "Discover response", ""]
715a717,719
elif itemType == self.getInternalNumber("DISCOVER_RESPONSE"):
# 21 Ignore
pass
P.S. Indigo 2022.1 is complaining about this plugin that it won't be supported in future releases. Is there anyone out there planning to update this plugin?
Advantage of this sensor is fast and easy installing by the non qualified personal. The sensor is designed for large agriculture facility with many greenhouses where is needed to be controlled temperature and humidity, the atmospheric pressure is for control the motor of air inlet and outlet. With help of the sensor installed outside the greenhouse provide information about positive/negative pressure inside the greenhouse.
Finlay the software read accurate temp/humid value of the Si7021, and only atmospheric pressure of BMP180, the temperature sensor inside the BMP180 is used only by the sensor itself to provide accurate atmospheric pressure measurements.
The sensor can be used also for home automation, and drone applications where is needed correction of the UAV barometric sensor compared to the ground barometric sensor, also humidity measurement can help the pilot to calculate more accurate flying time.
@TON-RIJNAARD You need to select the board based on the bootloader you have flashed. Complile the code in Arduino and try burning the hex file using a programmer (USBasp, AVRISP, etc..) if are facing issues with Arduino.
Qu3Uk,
I did get a chance to test with a Fitbit recently. It technically worked, but not all that well. The thing is, the Fitbit only advertises every 2 seconds so latency is a bit high. But worse, its apps really want to be connected to it often to sync; and whenever it's connected, it stops advertising and the detector then can't pick it up.
TommySharp,
At this point I don't plan to modify the board much but having it read environmental sensors would be a cool feature!
For that, would be nice to make little beacons that read sensors and advertise/broadcast the readings every few seconds. Then they could be very low-power, run on coin-cells for months, and could be placed anywhere instead of needing it to be hooked up to USB power like the main board is. Like these: https://sen.se/peanuts/ I'm curious if it could read them.
As for enclosures, I know. I would love to have some nice ones but at this point I'm making too many boards to 3D print enclosures, but too few to afford injection-molding tooling to make a custom case.
