Not yet !
In fact, the interrupt must be short enough and fast enough to be sure to not miss the RFM69 interrupts.
The code for 8 dimmers will not be really more complicated : in fact, each time we got a zero cross, we must set a timer to zero, and then wait the good amount of milliseconds to turn on the needed outputs.
So, yes, we'll have an interrupts each 10ms (each time the wave crosses the zero, to be precise !), but I think all we have to do in the interrupt handler is set the timer to zero (or to micros() ...) and then on the main loop, wait the good amount of time for each output before setting them ON.
Seems simple on paper, perhaps it will not work on the chip....
In facts, my main concern is : will the RFM interrupt be short enough to not disturb the zero crossing interrupt ?
Although, not yet tested the RFM : do we NEED the interrupt pin ? Can't we poll frequently the RFM?
I've updated the docs at home-assistant.io with sketch examples. Look at the light example.
https://home-assistant.io/components/light.mysensors/#example-sketch
It's what I used for testing during development. It adds an RGB sensor/actuator also besides a dimmer, but you can just remove any references to rgb in the sketch.
The dimmer slider will only be visible after turning on the light and clicking the entity in the gui to bring up the more info card.
Do you have interest to try OH2 together with MySensors Ethernet Gateway to get working?
I do not have enough force to push developers to make this happen. At the moment there is some problem on this, because full control is not possible. I think that MySensors Serial Gateway is working with OH2, but I don't like to use it. I like to connect my devices into LAN not cabling via old fashioned way using serial wires.
This should work with Domoticz, it's what I intend to use with it. I've received the boards from China and I'm currently working on a version 2 of this board. There are some errors in the design of version 1 that I need to get out. New version will be up shortly.